/boot.config: -DConsoles: internal video/keyboard  serial port  
BIOS drive C: is disk0
BIOS 639kB/261120kB available memory

FreeBSD/i386 bootstrap loader, Revision 1.1
(sullrich@freebsd7-releng_1_2_1.pfsense.org, Thu Jan  8 22:51:03 EST 2009)
Loading /boot/defaults/loader.conf 
/boot/kernel/kernel text=0x66a3a8 data=0x9af2c+0x4d960 
Hit [Enter] to boot immediately, or any other key for command prompt.

Booting [/boot/kernel/kernel] in 4 seconds... 
Booting [/boot/kernel/kernel] in 3 seconds... 
Booting [/boot/kernel/kernel] in 2 seconds... 
Booting [/boot/kernel/kernel] in 1 second... 
Booting [/boot/kernel/kernel]...               
Copyright (c) 1992-2008 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 7.0-RELEASE-p8 #0: Thu Jan  8 23:06:42 EST 2009
    sullrich@freebsd7-releng_1_2_1.pfsense.org:/usr/obj.pfSense/usr/src/sys/pfSense_wrap.7
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Celeron(TM) CPU                1200MHz (1202.73-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x6b4  Stepping = 4
  Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory  = 268435456 (256 MB)
avail memory = 252833792 (241 MB)
wlan: mac acl policy registered
ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
cryptosoft0: <software crypto> on motherboard
cpu0 on motherboard
pcib0: <Intel 82815 (i815 GMCH) Host To Hub bridge> pcibus 0 on motherboard
pir0: <PCI Interrupt Routing Table: 11 Entries> on motherboard
$PIR: Using invalid BIOS IRQ 9 from 2.13.INTA for link 0x63
pci0: <PCI bus> on pcib0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pcib2: <PCIBIOS PCI-PCI bridge> at device 30.0 on pci0
pci2: <PCI bus> on pcib2
safe0 mem 0xe7bfe000-0xe7bfffff irq 3 at device 6.0 on pci2
safe0: [ITHREAD]
safe0: SafeNet SafeXcel-1141 rng des/3des aes md5 sha1 null
re0: <RealTek 8139C+ 10/100BaseTX> port 0xd500-0xd5ff mem 0xefefa000-0xefefa1ff irq 10 at device 9.0 on pci2
re0: Chip rev. 0x74800000
re0: MAC rev. 0x00000000
miibus0: <MII bus> on re0
rlphy0: <RealTek internal media interface> PHY 0 on miibus0
rlphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
re0: Ethernet address: 00:90:7f:2e:7c:08
re0: [FILTER]
re1: <RealTek 8139C+ 10/100BaseTX> port 0xd600-0xd6ff mem 0xefefb000-0xefefb1ff irq 5 at device 10.0 on pci2
re1: Chip rev. 0x74800000
re1: MAC rev. 0x00000000
miibus1: <MII bus> on re1
rlphy1: <RealTek internal media interface> PHY 0 on miibus1
rlphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
re1: Ethernet address: 00:90:7f:2e:7c:09
re1: [FILTER]
re2: <RealTek 8139C+ 10/100BaseTX> port 0xd900-0xd9ff mem 0xefefc000-0xefefc1ff irq 11 at device 11.0 on pci2
re2: Chip rev. 0x74800000
re2: MAC rev. 0x00000000
miibus2: <MII bus> on re2
rlphy2: <RealTek internal media interface> PHY 0 on miibus2
rlphy2:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
re2: Ethernet address: 00:90:7f:2e:7c:0a
re2: [FILTER]
re3: <RealTek 8139C+ 10/100BaseTX> port 0xda00-0xdaff mem 0xefefd000-0xefefd1ff irq 12 at device 12.0 on pci2
re3: Chip rev. 0x74800000
re3: MAC rev. 0x00000000
miibus3: <MII bus> on re3
rlphy3: <RealTek internal media interface> PHY 0 on miibus3
rlphy3:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
re3: Ethernet address: 00:90:7f:2e:7c:0b
re3: [FILTER]
re4: <RealTek 8139C+ 10/100BaseTX> port 0xdd00-0xddff mem 0xefefe000-0xefefe1ff irq 9 at device 13.0 on pci2
re4: Chip rev. 0x74800000
re4: MAC rev. 0x00000000
miibus4: <MII bus> on re4
rlphy4: <RealTek internal media interface> PHY 0 on miibus4
rlphy4:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
re4: Ethernet address: 00:90:7f:2e:7c:0c
re4: [FILTER]
re5: <RealTek 8139C+ 10/100BaseTX> port 0xde00-0xdeff mem 0xefeff000-0xefeff1ff irq 6 at device 14.0 on pci2
re5: Chip rev. 0x74800000
re5: MAC rev. 0x00000000
miibus5: <MII bus> on re5
rlphy5: <RealTek internal media interface> PHY 0 on miibus5
rlphy5:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
re5: Ethernet address: 00:90:7f:2e:7c:0d
re5: [FILTER]
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH2 UDMA100 controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xff00-0xff0f at device 31.1 on pci0
ata0: <ATA channel 0> on atapci0
ata0: [ITHREAD]
ata1: <ATA channel 1> on atapci0
ata1: [ITHREAD]
orm0: <ISA Option ROM> at iomem 0xe0000-0xe0fff pnpid ORM0000 on isa0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/16 bytes threshold
ppbus0: <Parallel port bus> on ppc0
ppbus0: [ITHREAD]
ppi0: <Parallel I/O> on ppbus0
ppc0: [GIANT-LOCKED]
ppc0: [ITHREAD]
sio0 at port 0x3f8-0x3ff irq 4 flags 0x30 on isa0
sio0: type 16550A, console
sio0: [FILTER]
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
unknown: <PNP0c01> can't assign resources (memory)
speaker0: <PC speaker> at port 0x61 pnpid PNP0800 on isa0
unknown: <PNP0501> can't assign resources (port)
unknown: <PNP0401> can't assign resources (port)
RTC BIOS diagnostic error 20<config_unit>
Timecounter "TSC" frequency 1202732278 Hz quality 800
Timecounters tick every 10.000 msec
Fast IPsec: Initialized Security Association Processing.
ad0: 977MB <SanDisk SDCFH-1024 HDX 3.03> at ata0-master PIO4
GEOM_LABEL: Label for provider ad0a is ufs/pfSense.
GEOM_LABEL: Label for provider ad0d is ufs/pfSenseCfg.
Trying to mount root from ufs:/dev/ufs/pfSense

     ___
 ___/ f \
/ p \___/ Sense
\___/   \
    \___/

Welcome to pfSense 1.2.2 on the 'embedded' platform...

Setting up embedded specific environment... done.
Mounting filesystems... done.
Creating symlinks......done.
Launching PHP init system... done.
Initializing.................. done.
Starting device manager (devd)...done.
Loading configuration......done.
Updating configuration...done.
Cleaning backup cache...done.
Setting up extended sysctls...done.
Syncing user passwords...done.
Starting Secure Shell Services...done.
Setting timezone...done.
Starting syslog...done.
Configuring LAN interface...done.
Configuring WAN interface...done.
Configuring OPT interfaces...done.
Configuring CARP interfaces...done.
Starting OpenNTP time client...done.
Configuring firewall......done.
Starting webConfigurator...done.
Starting DNS forwarder...done.
Starting DynDNS client...done.
Setting up microcode and tx/rx offloading...done.
Configuring IPsec VPN... done
Starting FTP helpers...done.
Starting SNMP daemon... done.
Final filter pass......done.
Generating RRD graphs...done.
Starting CRON... done.
Syncing packages: siproxd
Beginning package installation for ...

Installing siproxd and its dependencies.
Executing rc.d items... 
 Starting /usr/local/etc/rc.d/*.sh...done.
appending output to nohup.out
Bootup complete

FreeBSD/i386 (pfSense.sampas.net) (console)


*** Welcome to pfSense 1.2.2-embedded on pfSense ***

  WAN                      ->	re0	->	NONE(DHCP)
  LAN*                     ->	re1	->	x.x.x.x

 pfSense console setup 
***********************
 0)  Logout (SSH only)
 1)  Assign Interfaces
 2)  Set LAN IP address
 3)  Reset webConfigurator password
 4)  Reset to factory defaults
 5)  Reboot system
 6)  Halt syst